What does a Berg connector do?
Sometimes labeled on the cable as P7, the Berg connector is a power connection developed by Berg Electronics. It is used with computer power supplies that connect to floppy disk drives, front panel lights, and reset or turbo buttons.
How much power does Molex put out?
54 watts
The ATX standard for SATA or Molex connections is rated for 54 watts. Each SATA/Molex connector provides three 12v pins at 1.5 amps each, for a total of 4.5 amps. 12 volts, times 4.5 amps, equals 54 watts able to be provided by a SATA/Molex connector.
What is the function of 4 pin Berg connector?
the four-pin polarized Berg connectors used to connect 3½-inch floppy disk drive units to the power supply unit, usually referred to as simply a “floppy power connector”, but often also referred to as LP4. This connector has a 2.50 mm (0.098 in) pitch (not 2.54 mm).
How much power does a floppy drive use?
about one half Watt
The floppy drive consumes about one half Watt of power, so the savings are small. But big savings can come from many small cuts, so the device was left unplugged.
What is Berg mini Molex connector used to )?
The 2-pin Berg connector is used in connections for turbo switches, front panel lights, jumpers for motherboard configuration and reset button to the motherboard of the computer. Like most connectors, Berg connectors were also keyed in order to avoid improper connections or incorrect mating.
What is the 24 pin connector for?
A 24-pin power supply adds an extra line each of 3.3 volts, 5 volts, and 12 volts, as well as an additional ground. These extra lines are used to satisfy the needs of newer technologies and more power-hungry peripherals. They also replace older 12 volt auxiliary connectors found on some 20-pin motherboards.
What is a 20-pin connector?
It is one of the largest connectors inside a computer. It connects a power supply to an ATX style motherboard. As shown in the picture, the 20-pin cable is a multi-color cable and may be labeled as P1.
What is the function of 20-pin Molex ATX power connector?
The 20/24 pin ATX provides primary power to the system. It powers all directly connected components and SMDs, and provides power to PCI-E devices.
Which connector is used for video card?
If the GPU requires more than 150 watts, it will come with an 8-pin connector or two 6-pin connectors. As always, there are exceptions. The most power-hungry graphics cards will come with a 6-pin and an 8-pin connector.
What does mini DIN stand for?
Many professional disc jockey components feature a mini-DIN connector. Originally developed by the Deutsches Institut fur Normung (DIN), which means the “German Institute for Standardization,” the mini-DIN connector is a round plug containing a varying number of pins.
Is Molex better than SATA?
Technically Molex can carry much more power than the SATA power connector. Molex has 2 power pins (one 5V and on 12V pin), each can deliver 11Amps for a total of 22Amps.
Is SATA and Molex the same?
Molex connections have four large pins, which are shaped similar to the ground prong on an AC cord. SATA connections, on the other hand, have a flat, 15-pin design that looks much more advanced. Typically, molex connections are found on older drives, or on larger 3.5 or 5.5-inch drives.